Pedders Heavy Duty Load Carrying and Towing Suspension Kit. With supplementary airbags. Mitsubishi L200

Pedders Heavy Duty Load Carrying and Towing Suspension Kit. With supplementary airbags. Mitsubishi L200

Improved load carrying and towing ability and ground clearance.
Do you use your L200 for load carrying and/or towing?
Then Pedders Suspension have the solution for you.
This kit features our excellent Pedders TrakRyder Foam Cell shocks, new rear leaf springs as well as the necessary bushes and U bolts to install them. Additionally I has supplementary air bags.
This kit is our second level heavy duty kit and is designed primarily to raise the vehicle and improve its load carrying and towing ability. If your Ranger currently’sits low at the rear when towing or load carrying, but you still also operate in the unladen condition, then this kit offers a significant improvement compared to the standard vehicle.
This kit is for those who subject there vehicle to significant changes in load on a regular basis, and for whom the fully laden condition is greater than our Heavy Duty kits 803188 or 803189 can accommodate and where a stiffer rear spring would introduce an unacceptably harsh ride in the lightly laden state..
Typical applications are vehicle used by window cleaners with a large water tank installed which will vary from empty to full.
This kit improves the load carrying ability compared to the standard L200 Ranger rear spring whilst still allowing operation in the lightly laden state. (we recommend a minimum of 200Kg)
Whilst the rear spring in this kit is heavier duty than the standard spring there is a limit to what in can support. To assist with this, this kit comes with supplementary air bags. These are installed between the rear leaf springs and the chassis rails. The kit as supplied requires these to be inflated with an airline (the same as used to inflate your tyres) when heavily laden in order raise the rear of the vehicle to an acceptable height. An “on board” air option is available by purchasing our kit 499000.
This kit will raise the rear of the vehicle by approx. 20mm (see actual dimensions below) allowing better ground clearance. The dimensions quoted assume a standard vehicle. If you have additional equipment on board at the front such as a winch or bull bar, this will affect the final installed height. If this is the case, please contact us as it may be necessary to supply different springs for your application.
For those using the vehicle in a continuously laden state, consider or Extra Heavy Duty kit 803189.
Still not sure this is the correct kit for you? Have further questions? Then please do get in touch with one of our team here at Pedders who will be able to assist you.

Key features

• Improved load carrying and towing
• Sintered Iron Piston Shocks with Large 45mm Bore
• Premium Grade Steel Coils
• All backed by our 2 year / 40,000km warranty

Vehicle Height Information

Front: N/A
Rear: Approx 20mm higher than standard.
Notes: Heights should be measured as shown in the secondary picture.

Suitable for:

Mitsubishi/L200/2WD, ML (Coil over Frt) | 2006-2009/2WD, ML (Coil over Frt) – Kits
Mitsubishi/L200/2WD, MN | 2008-2015/2WD, MN – Kits
Mitsubishi/L200/4WD, ML (Coil over Frt) | 2006-2009/4WD, ML (Coil over Frt) – Kits
Mitsubishi/L200/4WD, MN | 2009-2015/4WD, MN – Kits